CEM DT-337 User Manual

7
600V
V
%Hz/
600V
Hz/%
V
80A
AC
4A
V
4A
80A
OFF
AC
4A
V
OFF
4A
80A
80A
Operation
NOTICES: Read and understand all warning and
precaution statements listed in the safety
section of this operation manual prior to using
this meter. Set the function select switch to the
OFF position when the meter is not in use.
AC/DC Current Measurements
WARNING: Ensure that the test
leads are disconnected from the
meter before making current clamp
measurements.
1. Set the Function switch to the
80ADC, 4ADC, 80AAC or 4AAC
range. If the range of the
measured is not known, select
the higher range first then move
to the lower range if necessary.
2. Press the trigger to open jaw. Fully enclose one
conductor
to be measured.
3. If is DCA measurement need press ZERO button to
enter the zero reading.
3. The clamp meter LCD will display the reading.

CEM DT-337 Specifications

General

Brand	CEM
Model	DT-337
Category	Measuring Instruments
Language	English