CEM DT-932N - TEMPERATURE MEASUREMENTS; Warning for Temperature Measurement; Procedure for Temperature Measurement; Post-Measurement Warning

20
TEMPERATURE MEASUREMENTS
WARNING: To avoid electric shock, disconnect both test probes
from any source of voltage before making a temperature
measurement.
1. If you wish to measure temperature in
o
F, set the function switch to
the
o
F range. If you wish to measure temperature in
o
C, set the function
switch to the
o
C range.
2. Insert the type K thermocouple probe black test lead banana
plug into the negative COM jack and the red test lead banana
plug into the positive Temp jack..
3. Touch the Temperature Probe head to the part whose temperature you
wish to measure. Keep the probe touching the part under test until the
reading stabilizes (about 30 seconds).
4. Read the temperature in the display. The digital reading will indicate the
proper decimal point and value.
WARNING: To avoid electric shock, be sure the thermocouple has been
removed before changing to another measurement function.