To Next PageTo Next Page
Need help?Do you have a question about the Cembre B500 and is the answer not in the manual?
Outlines the necessary steps and checks before starting any operation with the tool.
Explains how to activate the motor-pump to advance the dies to the desired position.
Details the process of performing a crimp by keeping the operating button pressed until pressure is reached.
Describes how to retract the ram and open the dies using the pressure release button.
Information on the integrated LED worklights that illuminate the compression area during operation.
Explains the functionality of the tool head's 180° rotation for user comfort.
Instructions for using the touch button to navigate and select options on the tool's display.
How to check the remaining battery life using LED indicators and the tool's display.
Guidance on how to use the battery charger according to its user manual.
Procedures for daily cleaning of the tool to prevent damage from dust, sand, and dirt.
Recommendations for storing and transporting the tool safely in its dedicated case.
Describes pre-determined parameters displayed on the tool at startup and during operation.
Details how to change control parameters and settings using the touch button.
Explains warning messages that appear during operation indicating tool status or conditions.
Lists common error messages, their descriptions, and recommended solutions for operational issues.
General| Crimping Force | 60 kN |
|---|---|
| Battery Voltage | 18 V |
| Battery Capacity | 2.0 Ah |
| Type | Hydraulic crimping tool |
| Working Pressure | 700 bar (70 MPa) |
| Pump Type | Electro-hydraulic |
