CEN-TECH 60431 User Manual (English)

Other manuals for CEN-TECH 60431

Questions and Answers:

R
Randall KellyAug 13, 2025
What to do if CEN-TECH 60431 Battery Charger needle moves to full charge then drops to zero?
- J
  Jordan BushAug 13, 2025
  If the Charge Meter needle moves up to full charge and then drops to zero while making a clicking noise, here's what might be happening and what you can do: * **Reversed battery connections:** Double-check the connection polarity. If it's wrong, shut off the charger and correct the cable lead connections. * **Battery is completely dead:** Continue charging the battery. The charger will continue to reset itself until the battery reaches a chargeable level. * **Defective battery:** Check and/or replace the battery. * **Charger is resetting:** Wait until the Charger automatically resets itself after a circuit overload. * **Circuit breaker is cycling:** The switch might be in the wrong position.
S
Sarah MillerAug 16, 2025
Why is my CEN-TECH Battery Charger charging current not at full output?
- S
  susanandradeAug 16, 2025
  The charging current might not be at full output for these reasons: * The battery may already be partially charged, in which case, continue charging the battery. * The battery could be defective and unable to hold a full charge. In this case, check or replace the battery.
S
Sabrina SmallAug 21, 2025
How to fix CEN-TECH 60431 with no charge meter reading?
- C
  Cristian JohnsonAug 21, 2025
  If there is no Charge Meter reading on your CEN-TECH Battery Charger, consider the following possibilities: * **Battery not connected:** Connect the battery to the charger. The Charge Meter will not show a reading until a battery is attached. * **No power to charger:** Check the power and cable outlet connections. * **Battery cables not making connection:** Clean the battery cables and reset the cable clamps. * **Two-amp charge rate being used:** The meter will not indicate at this rate.