Page 13For technical questions, please call 1-888-866-5797.Item 60703
SAFETYOPERATIONMAINTENANCE SETUP
Inverter Troubleshooting
Problem Possible Causes Possible Solutions
Lack of Inverter
power output.
1. Power Pack voltage
at or below 12V.
2. Excessive current drawn
during operation.
3. Inverter not completely
warmed up.
1. Recharge the Power Pack immediately.
2. Reduce load to 200 watts.
3. Turn off Inverter. Disconnect device. Turn
Inverter on and leave running for at least two
minutes. Turn off Inverter, quickly plug device
to Inverter, making sure device is OFF before
connecting. Turn on Inverter and device.
Inverter LED
Light off.
1. Inadequate power or
excessive voltage drop.
2. Inverter is overloaded.
1. Check Power Pack and recharge
if voltage drops below 12V.
2. Reduce load to 200 watts.
Appliance/device
won’t operate.
High surge wattage
required to start-up.
Toggle the Inverter On/Off switch five times in quick
succession to generate the necessary power. If
the device does not turn on or start up after five
cycles, this Inverter will not work with this device.
Picture breaking
up/”snow”.
(for television)
Signal interference. 1. Place Inverter as far as possible from TV.
Static/noise
interference
Using sound system with
low quality noise filtering.
Use only with audio system that has a
high quality noise filtering system.
Follow all safety precautions whenever diagnosing or servicing the Power Pack.
Disconnect power supply before service.
To Next Page
Loading...
Need help?
General
