Need help?Do you have a question about the Central Machinery 33686 and is the answer not in the manual?
Steps to take before operating the machine.
Steps to take after operating the machine.
Instructions for adjusting the machine head.
Steps for loosening motor, adjusting tension, and setting pulleys.
Diagnosing why the machine won't start.
Troubleshooting motor issues like overheating or lack of power.
Addressing spindle bearing temp, power, shake, and micro feed problems.
Steps to take before operating the machine.
Steps to take after operating the machine.
Instructions for adjusting the machine head.
Steps for loosening motor, adjusting tension, and setting pulleys.
Diagnosing why the machine won't start.
Troubleshooting motor issues like overheating or lack of power.
Addressing spindle bearing temp, power, shake, and micro feed problems.
General| Voltage | 120V |
|---|---|
| Motor | 1/2 HP |
| Type | Benchtop |
| Chuck Size | 1/2 inch |
| Swing | 10 inch |
| Table Tilt | 45 degrees left and right |
| Column Diameter | 2-3/8 inch |
To Next Page