GASOLINE AUGER DRILL
1.5 HP
ASSEMBLY AND OPERATION INSTRUCTIONS
Due to continuing improvements, actual product may differ slightly from the product described herein.
CAUTION!
Your Warranty Is Voided If:
You do not operate the Auger Drill with the proper 25:1 unleaded fuel/2-cycle oil mix in its fuel tank. Do not
run the Engine with an improper fuel mix, low or no fuel mix. Running the Engine with an improper fuel mix,
low or no fuel mix, will permanently damage the unit.
You do not operate the Auger Drill with the proper amount of SAE 80-90 gear oil in its Gearbox. Do not run the
Auger Drill with low or no gear oil. Running the Auger Drill with low or no gear oil will permanently damage
the unit.
Distributed exclusively by
Harbor Freight Tools
®
.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND
ALL WARNINGS AND INSTRUCTIONS BEFORE USE.
Copyright
©
2006 by Harbor Freight Tools
®
. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions or replacement parts, please call 1-800-444-3353.
Manual Revised 07b, 07e
To Next Page
Need help?
General
