Central Machinery 42827 User Manual

Geared Head
Drill / Mill Machine
Model
42827 42827
42827 42827
42827
Assembly & Operating Instructions
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright
©
2005 by Harbor Freight Tools
®
. All rights reserved. No portion of this manual or any
artwork contained herein may be reproduced in any shape or form without the express written
consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.
TO PREVENT SERIOUS INJURY,
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.

Central Machinery 42827 Specifications

General

Type	Drill Press
Voltage	120V
Speeds	5
Chuck Size	1/2 inch
Table Tilt	45 degrees left and right

Summary

Assembly & Operating Instructions

SAFETY WARNING & CAUTIONS

General Safety Guidelines

Covers 13 essential safety rules for operating tools and machinery, focusing on workspace and personal protection.

Specific Operational Hazards

Details special warnings for drilling/milling, electrical safety, ejected material, and entanglement risks.

FEATURES AND CONTROLS OVERVIEW

UNPACKING AND INSTALLATION

BASIC OPERATION

INSTALLING AND CHANGING TOOLS

ADDITIONAL SAFETY RULES AND SPECIFICATIONS

TROUBLESHOOTING GUIDE

Machine Startup Issues

Diagnoses issues when the machine fails to start, checking power, switches, and gears.

Motor Performance Problems

Troubleshoots motor heat issues, low power, and potential electrical or component failures.

Spindle Bearing Overheating

Addresses causes of hot spindle bearings, including lubrication and adjustment issues.

Table Movement and Feed Issues

Identifies and resolves issues causing unbalanced table movement and feed problems.

Cut Quality and Vibration

Micro Feed Mechanism

Machining Accuracy Problems

ELECTRICAL REQUIREMENTS AND WIRING

MAINTENANCE SCHEDULE