Page 4SKU 45656 For technical questions, please call 1-800-444-3353.
(SEE FIGURES A, B, E, AND ASSY. DIAGRAM E.)
2. USE CLEAN, DRY, REGULATED COMPRESSED AIR AT UP TO 110 PSI. Do
not exceed the recommended maximum of 110 PSI. Never use oxygen, carbon
dioxide, combustible gases or any other bottled gas as a power source for this
tool.
3. WHEN CONNECTING TO THE AIR SUPPLY:
A. Wrap approximately 4” of Teon tape around the male threads of a Quick
Connector (not provided). Then, wrench tighten the Quick Connector into the
Pressure Regulator (5F). (See Figures A, C, and E.)
B. If an automatic oiler is not used, add two drops of oil into the Quick Connector
of the Pressure Regulator (5F).
To Next Page
Loading...
