Central Machinery 93212 Quick Start Guide

QUICK START GUIDE
7" x 10"
PRECISION MINI LATHE
TO START
6
A. Turn Variable Speed
Control Knob to “0”.
B. Move Forward-OFF-
Reverse Switch to
“OFF” position.
C. Move Power Switch
to “OFF” position.
D. Unplug the Lathe.
TO STOP
5
Copyright
©
2012 by Harbor Freight Tools
®
. All rights reserved. REV: 14c
Read the user manual completely before using this product. Failure to do
so can result in serious injury.
Always wear ANSI-approved eye protection before using this product
A. Follow SET-UP on Reverse.
B. Close Chuck Guard.
STOP: MAKE SURE ALL FRONT
CONTROLS ARE SET TO “OFF”
OR “0”.
C. Plug in the Lathe.
D. Move Forward-OFF-Reverse
Switch to desired direction.
E. Move Power Switch to “ON”
position.
F. Turn Variable Speed Control
Knob to desired speed.
FORWARD
REVERSE
OFF
1
0
I
O
IMPORTANT: SEE MANUAL FOR DETAILED
INSTRUCTIONS OF THESE PROCEDURES.
FORWARD
REVERSE
I
O
OFF
1
0
Item: 93212

Central Machinery 93212 Specifications

General

Model	93212
Swing Over Bed	12 inches
Distance Between Centers	10 inches
Spindle Speed	Variable, 0-2500 RPM
Motor Power	3/4 HP
Motor	3/4 HP
Spindle bore	0.78 inches
Tailstock taper	MT2
Voltage	120V
Type	Lathe