Page 4 @+-*)/93='91<*A,/()'+=(B*4</1(/*91<<*CDEEEDE!!DF#"#6 Item 69724
GH@;IJ KL;MHINKO PHNOI;OHOQ;G;IRL
H'-*G+,-9/
1. O/_/-*9+==/9)*)+*1=*1'-*(+,-9/**
* )31)*'(*91410</*+7*/^9//>'=8**
* $bb*4('6 Over pressurizing the
tool may cause bursting, abnormal
operation, breakage of the tool or
serious injury to persons. Use only clean, dry,
regulated compressed air at the rated pressure
or within the rated pressure range as marked on
the tool. Always verify prior to using the tool that
the air source has been adjusted to the rated air
pressure or within the rated air-pressure range.
2. Never use oxygen, carbon dioxide, combustible
gases or any bottled gas as an air source
for the tool. Such gases are capable of
explosion and serious injury to persons.
*GH&;*IY;G;*NOGIMRQINKOG6
G]:0+<(*1=>*G4/9'7'9*G17/)]*N=()-,9)'+=(
G]:0+<*W/7'=')'+=(
G]:0+< L-+4/-)]*+-*()1)/:/=)
=
+
No-load speed
6665:'=
Revolutions or reciprocation per minute
LGN
Pounds per square inch of pressure
7)D<0
Foot-pounds of torque
ULP
Blows per minute
Q@P
Cubic Feet per Minute flow
GQ@P
Cubic Feet per Minute flow
at standard conditions
G]:0+< L-+4/-)]*+-*()1)/:/=)
OLI
National pipe thread, tapered
OLG
National pipe thread, straight
WARNING marking
concerning Risk of Eye Injury.
Wear ANSI-approved eye protection.
WARNING marking concerning Risk of
Hearing Loss. Wear hearing protection.
WARNING marking concerning
Risk of Respiratory Injury. Wear
NIOSH-approved dust mask/respirator.
WARNING marking concerning
Risk of Explosion.
G4/9'7'9*G17/)]*N=()-,9)'+=(
1. The warnings and precautions discussed in this
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
2. Only use with accessories rated to handle the
forces exerted by this tool during operation.
Other accessories not designed for the forces
generated may break and forcefully launch pieces.
3. Obey the manual for the air compressor
used to power this tool.
4. Install an in-line shutoff valve to allow
immediate control over the air supply in an
emergency, even if a hose is ruptured.
5. Use this tool with both hands only. Using tools
with only one hand can result in loss of control.
6. Do not lay the tool down until it has come to
a complete stop. Moving parts can grab the
surface and pull the tool out of your control.
To Next Page
Loading...
