To Next PageTo Next Page
Need help?Do you have a question about the CentraLine CLIOP831A and is the answer not in the manual?
General safety precautions for installation and operation of the controller system.
Safety requirements and system data according to EN60730-1 standard.
Guidance on selecting appropriate transformers for the system.
Guidelines for selecting fuses for modules and devices.
Instructions for installing and removing modules and sockets.
Instructions for installing and removing electronic modules.
General safety rules for wiring and system setup.
Wiring specifications for push-in and screw-type terminals.
Connecting power supply, transformers, and DC supplies.
Wiring controllers without bridge connectors.
Correct and incorrect wiring examples for mixed bus systems.
Assigning unique addresses to Panel Bus I/O modules.
Process for commissioning Panel Bus and LONWORKS I/O modules.
Types, descriptions, and housing of analog input modules.
Description of analog input module terminals and internal connections.
Wiring example for active sensor and potentiometer.
Wiring example for passive sensor and 0-20 mA signal.
Wiring example for CLIOP822A analog output module.
Wiring example using the MCD 3 relay module.
Wiring example using the MCE 3 relay module.
Wiring example for CLIOP823A binary input module.
Lists relay output modules and their terminal sockets.
Wiring example for CLIOP824A relay output module.
General troubleshooting for CentraLine I/O modules.
Meaning and remedies for Service LED states.
Troubleshooting specific failures for analog input modules.
Troubleshooting failures for analog, binary, relay, and floating output modules.
General safety precautions for installation and operation of the controller system.
Safety requirements and system data according to EN60730-1 standard.
Guidance on selecting appropriate transformers for the system.
Guidelines for selecting fuses for modules and devices.
Instructions for installing and removing modules and sockets.
Instructions for installing and removing electronic modules.
General safety rules for wiring and system setup.
Wiring specifications for push-in and screw-type terminals.
Connecting power supply, transformers, and DC supplies.
Wiring controllers without bridge connectors.
Correct and incorrect wiring examples for mixed bus systems.
Assigning unique addresses to Panel Bus I/O modules.
Process for commissioning Panel Bus and LONWORKS I/O modules.
Types, descriptions, and housing of analog input modules.
Description of analog input module terminals and internal connections.
Wiring example for active sensor and potentiometer.
Wiring example for passive sensor and 0-20 mA signal.
Wiring example for CLIOP822A analog output module.
Wiring example using the MCD 3 relay module.
Wiring example using the MCE 3 relay module.
Wiring example for CLIOP823A binary input module.
Lists relay output modules and their terminal sockets.
Wiring example for CLIOP824A relay output module.
General troubleshooting for CentraLine I/O modules.
Meaning and remedies for Service LED states.
Troubleshooting specific failures for analog input modules.
Troubleshooting failures for analog, binary, relay, and floating output modules.
General| Model | CLIOP831A |
|---|---|
| Category | Control Unit |
| Product type | Programmable Controller |
| Digital inputs | 8 |
| Digital outputs | 8 |
| Communication | BACnet MS/TP, Modbus RTU |
| Analog Inputs | 4 |
| Analog Outputs | 2 |
| Relative Humidity | 5 to 95% non-condensing |
| Dimensions | 110 x 90 x 60 mm |
| Operating Temperature | -10 to 50 °C |
