Frequency intensity 40/70/100 µT
Each frequency is available in the intensity levels
40 μT, 70 μT and 100 μT. Please note that the
intensity also aects the power consumption of
the
B
2
. This means that if you continuously use
frequency programs with a high intensity, you will
need to charge the battery sooner than if you use a
low intensity or frequency.
Autopilot
The basic package oers fully automatic adjustment
of the four powerful Schumann frequencies and
the three intensity levels. The
BUBBLE
2
and its
intelligent charging station able to call up the current
Schumann resonance frequencies on a daily basis
and automatically nd the optimum setting for the
day. To do this, simply place your
BUBBLE
2
on the
charging station for a few seconds once a day or
as required.
Battery exchange
Turn the cover clockwise (see description under
description under „Changing the cover“) to gain
access to the battery. Gently tap the battery out
of the housing, e.g. on a tabletop. Please do not
lever the battery out with a pointed object. This
can damage the battery clamps or the battery
holding system. Insert the new rechargeable battery
(Rechargeable
LIR2032)
in the same place (please do
NOT use a standard CR2032 battery!) until it clicks
securely into place. Now close the
BUBBLE
2
with
the cover again and make sure that the rubber
sealing ring is positioned correctly before putting
on the cover.
Sleep Mode
The sleep mode of the
BUBBLE
2
is activated if the
battery change takes longer than 20 seconds and
the circuit is therefore interrupted. To end sleep
mode, simply place the
BUBBLE
2
on the switched-on
charger.
12
DE
EN
To Next Page
Loading...