CenturionPro Original - Blade Removal; Remove Blade and Magnet Bar; Clean Blade and Magnet Bar; Cleaning the Trimmer

cprosolutions. 1 855 535 0558
10
WARNING:
Avoid direct water
contact on motor
Clean with pressure-washer at 1500-2000 PSI.
Hot water, fan spray setting.
Run the machine for 15 minutes
aer washing. Allowing components to dry.
Clean the length of the Cutting Reel and
Shroud of all debris.
For optimal performance and life, the components must be cleaned every 2 to 3 days of use.
For optimal performance and life, the BLADES and the MAGNET BARS must be removed and cleaned every few hours of operation.
IMPORTANT NOTE: Your bed bar blade has been factory set to cut perfectly. Please do not alter the settings of your machine.
You might notice slight contact between your rotating cutting reel and the flat bed bar blade - this is normal.
Remove BLADE
then MAGNET BAR
carefully!
Clean BLADE and MAGNET
BAR with a utility knife.
Wipe clean with acetone.
BLADE
BLADE REMOVAL
CLEANING THE ORIGINAL & SILVER BULLET
For optimal performance and life, the components must be cleaned every 3 to 4 days of use.
Clean the Brush using
pressure washer
Clean the length of the
CUTTING REEL and
SHROUD of
all debris
Avoid
water
on the
Clean with pressure-washer at 1500-2000 PSI.
Hot water, fan spray setting.
Run the Original or Silver Bullet for 15 minutes
after washing. Allowing components to dry.