cprosolutions. 1 855 535 0558
20
TROUBLESHOOTING
1) There is a high-speed ticking sound coming from the blades
This is normal. The ticking sounds are the blades making slight contact. If the machine is producing a louder
than usual ticking/banging sound, then turn off the machine and inspect the blades. Ensure your blades are
properly adjusted by following our video tutorial “Adjusting the Bed Bar Blade”
2) My product is not exiting out of the tumbler
The tumbler should always be 50%-60% full. You should be feeding the tumbler every 30-45 seconds, this
will ensure that new product entering the machine will help push out product that is trimmed. You can also
increase the downward slope of the machine. To do this place a piece of cardboard underneath the input
side wheels. You may also remove the plastic lid to help increase output.
3) My leaf collector is not turning on
Ensure the correct voltage is being supplied as per your manual and never use an extension cord longer than
25 ft. Also, test your electrical current to make sure it is producing power. If it is, then your leaf collector’s
electrical box may need to be replaced.
4) My tumbler is spinning slower than usual or is not spinning
You will need to take a link (or two) out of the belt. Use a pair of needle nose plyers to help you with this.
When putting your tightened belt back on your machine it might be a little difficult. Use the video tutorial
“Removing and Replacing the Belt” to help you with this. Once the belt is tightened properly, the tumbler
speed will resume back to normal. Ensure that the tumbler is placed correctly in the grooves and there is no
lubricant on the Tumbler O Rings.
5) The leaf collector suction seems weak
Ensure that nothing is blocking the inlet or outlet on the leaf collector. Try cleaning your bags as this will keep
the suction performance high. Build up that occurs in the leaf collector around the impeller can cause the
suction to become weak as well. Unplug the leaf collector and follow cleaning instructions.
To Next Page
Loading...