Revision: 02/1015 DOK 1643-us 26 of 28
8.1 Cleaning
Pay attention that no humidity could penetrate into the device during cleaning.
Do not use solvents (e.g. benzene, alcohol, etc.) for cleaning!
Safe operation requires clean devices. Ensure that the devices (microphones,
connectors etc.) are clean and in good condition at all times.
Remove loose dust with a soft brush. Clean the outside of components, if necessary, with an
appropriate clean cloth, only lightly moistened with clear water, and then rub it down thoroughly. If
heavily soiled, a few drops of rinsing agent may be added. Clean the connector pins with a commercial
cleaning agent.
9 Disposal
Should equipment, supplied by CeoTronics, be definitely put out of service you
may return it to CeoTronics. We ensure recycling and/or disposal of outdated
equipment in compliance with the applicable environment protection law.
10 Technical data
Mechanical values
Specifications without plugs and cable sleeves
To Next Page
Loading...