20
model no. 399-0992-0 | contact us 1-844-428-7277
SYMPTOM CAUSE SOLUTION
Motor buzzes but fails to run. Supply voltage below minimum. Verify that only the pressure washer is
running on this circuit.
System has residual pressure. Turn unit OFF, squeeze trigger on spray wand
to release pressure, then turn unit ON.
Voltage loss due to extension cord. Unplug any extension cords attached and plug
the unit directly into the outlet.
Pressure washer not used for
long periods.
Call the toll-free hotline.
Residual friction among components.
Unit might hum.
Disconnect water supply and power ON for
2 to 3 seconds. Repeat this procedure a few
times, or until the motor starts.
No water. Water inlet filter is clogged. Remove filter and rinse with warm water.
Water supply is OFF (O). Turn ON (I) water supply.
Kink in the garden hose. Remove kink in garden hose.
TROUBLESHOOTING
IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED,
CALL CUSTOMER SERVICE AT 1-844-428-7277 FOR HELP.
VE17-Certified-Pressure-Washer-EN.indd 20 2019-01-18 10:17 AM
To Next Page
Loading...
