8
model no. 399-0992-0 | contact us 1-844-428-7277
SURFACE PREPARATION
Before starting any cleaning task, it is
important to inspect the area for objects
that could create a hazard. Remove any
objects from the work area that could
be tripped over, such as toys or outdoor
furniture. Ensure that all doors and windows
are closed tightly.
WATER SUPPLY (COLD WATER ONLY)
Only draw water through the unit. For use
with cold water supply only. Water hose must
be at least a 1/2” (13 mm) in diameter. Flow
rate of water supply must not fall below
2 gal/min (9.1 L/min). Flow rate can be
determined by running the water for one
minute into an empty 5 gallon (19 L)
container. The water supply temperature
must not exceed 104°F (40°C).
CAUTION
• Never use the pressure washer to draw in
water contaminated with solvents
(e.g., paint thinners, gasoline, oil, etc.)
• Dirt in the water inlet will damage the
unit. To avoid this risk, we recommend
checking the water filter (located inside
the water inlet; to clean it out, see
Maintenance section).
• Always prevent debris from being drawn
into the unit by using a clean water
source and an additional accessory water
filter if required.
• To prolong the life of the unit, rest the
unit for 5 minutes after every 30 minutes
of use.
Assemble the handle with hose reel to the
main unit with the provided screws. Tighten
the screws.
Assemble the gun holster and the
cord bracket.
ASSEMBLY AND OPERATING INSTRUCTIONS
1 2
VE17-Certified-Pressure-Washer-EN.indd 8 2019-01-18 10:17 AM
To Next Page
Loading...
