13
WORKING WITH FOAM BLASTER
Working with detergent ensures a quick soaking of the dirt, and allows the high-pressure
water to penetrate and remove the dirt more eectively. Always spray detergent on a dry
surface, do not pre-soak area. Wetting the surface first dilutes the detergent and reduces its
cleaning ability.
1. Detach spray head by turning detergent
bottle 1/4 turn counter-clockwise.
2. Fill the bottle with the detergent.
3. Reattach the spray head on to the bottle
by turning 1/4 turn clockwise.
Engage the safety lock on the spray gun.
1. Attach the foam blaster onto the spray
gun.
2. Apply the detergent to a dry work surface
from bottom to top.
3. Allow detergent to remain on the surface
for a short time before rinsing. Do not
allow detergent to dry on the surface.
4. When you are finish working with
detergent, fill the bottle with clean water
and spray water for one minute in ON
position to rinse the foam blaster and
remove any soap residues that may clog it.
1
2
ASSEMBLY AND OPERATING INSTRUCTIONS
1
3
2
CAUTION
Only use cleaning detergents recommended for pressure washers.
Damage may occure to painted surfaces if chemicals are allowed to
dry on them. Wash and rinse a small section at a time.
VE17-Certified-Pressure-Washer-EN.indd 13 2019-01-18 10:17 AM
®
To Next Page
Loading...
