CertoClav MultiControl 2 - Controller - Usage of Protocol Printer; Controller - Cleaning and Maintenance

Manual_MC2_DE_EN_V2.docx Page 12 of 44
CertoClav Sterilizer GmbH
Georg Grinninger-Str. 37
A-4050 Traun / Austria
www.certoclav.com support@certoclav.com
Controller - usage of protocol printer
After connecting a CertoClav protocol printer (Art. No. 1300187) the following protocol is
printed:
Header
10
Type of autoclave
15
Program name
30
Cycle number
Program steps
SxxA
Heat up
SxxH
Hold
SxxC
Drying
SxxE
End
Footer
40
Control message. Sterilization successful?
Controller – cleaning and maintenance
Cleaning
If necessary, the controller can be wiped with a moist, not wet, cloth.
Maintenance:
Maintenance must only be done by the manufacturer or an authorized body. No regular
maintenance necessary.