Cessna T303 - 5-24. FUSELAGE.; A. Fire Protection (Chapter 26).; B. Flight Controls (Chapter 27).; C. Oxygen (Chapter 35).

CESSNA
MODEL T303
MAINTENANCE
MANUAL
CESSNA
PROGRESSIVE
CARE
MODEL T303
OPERATION
NO. 1
MECH INSP REMARKS
5-24.
FUSELAGE.
A. Fire Protection
(Chapter
26).
(1) Fire
Warning Lights - Check
operation.
(2) Portable Hand Fire Extinguisher - Inspect for proper
operating pressure, security of installation and evidence
of damage.
B. Flight Controls (Chapter 27).
1) Aileron
Trim Tab Control and
Indicator - Inspect for se-
curity and evidence of damage. Operate control and
check freedom of movement. Inspect turnbuckle safety-
ing.
(2) Rudder
Trim Tab Control and
Indicator - Inspect for se-
curity and evidence of damage. Operate control and
check rudder trim tab for freedom of movement.
(3) Elevator Trim Tab Control and Indicator - Inspect for se-
curity and evidence of
damage. Operate both
manually
and electrically.
C. Oxygen (Chapter 35).
(1) Oxygen System
- Checkinstallation
and pressure.
(2)
Oxygen Regulator -
Check pressure and flow
rate.
(3) Oxygen
Masks and Hoses - Check
operation and clean.
(4) Oxygen
Cylinder - Inspect condition,
check hydrostatic
test date.
D. Equipment/Furnishings (Chapter 25).
(1) All Seats - Inspect seat rails for cracks, refer to Chapter
for limitations.
5-25. WINGS.
A. Wings (Chapter 57).
* (1) Wings
- Check for
loose rivets,
cracks, loose
mounting
fasteners and security.
(2) Wing Wheel Well - Check fume proofing.
(3) Wing Access Plates
- Inspect for security of installation
and
evidence of damage.
(4) Wing
Spar Fittings - Check bolts
for working and security.
*50-Hour
Requirement, Refer
to Paragraph 5-22,
B.
Page 3 of 9