Cessna T303 - 5-26. NACELLES.; A. Fire Protection (Chapter 26).; 5-27. TAILCONE.; A. Flight Controls (Chapter 27).

CESSNA
MODEL T303
MAINTENANCE MANUAL
CESSNA
PROGRESSIVE
CARE
MODEL T303
OPERATION
NO.
1
MECH
INSP
REMARKS
5-26.
NACELLES.
A.
Fire Protection
(Chapter 26).
(1) Detection
Control Unit
- Inspect
for security and
evidence of
damage.
5-27.
TAILCONE.
A.
Flight Controls
(Chapter 27).
(1) Rudder
- Inspect
the rudder
skins for cracks
and loose
rivets, rudder hinges,
hinge bolts, hinge
bearings and
hinge
attach
fittings for
evidence of
damage or
wear,
failed
fasteners and
security.
Check the
rudder hinge
bolts
for proper
safety of
nuts with
cotter pins.
(2)
Rudder
Bellcrank
- Inspect
bellcrank
stop
bolts for
prop-
er safetying,
corrosion,
evidence
of damage
and safety.
Inspect
bellcrank cables
for proper safetying.
(3) Rudder
Cables
- Check condition,
routing,
tension,
turnbuckle
safetying;
cables
in pulleys
and not
rubbing
on
structure.
(4) Rudder
Trim Tab
- Inspect
skins for cracks
and loose
rivets. Inspect
hinge for
security
and
evidence
of dam-
age,
hinge
pin for
proper
installation
and
cotter
pin
safetying.
Check
trim
tab travel.
Inspect
pushrods
for
evidence
of
damage
and security.
(5)
Rudder
Trim
Tab
Actuator
-
Inspect
actuator
for
security
and
evidence
of
damage,
service.
(6)
Rudder
Trim
Cables
- Inspect
condition,
routing,
ten-
sion,
turnbuckle
safetying;
cables
in pulleys
and
not
rubbing
on structure.
(7) Rudder
Gust
Lock
- Check
security,
wear
and
travel.
(8)
Yaw
Dampener
Actuator
and
Cables
-
Inspect
actuator
for
security,
mount
for cracks
and structure
for
evidence
of damage.
Inspect
cables
for fraying,
chafing,
routing,
cleanliness,
cable
tension
and
turnbuckle
safetying.
In-
spect
chains
for proper
alignment
on actuator
sproc-
kets.
(9)
Elevator
- Inspect
the
elevator
skins
for cracks
and
loose
rivets.
Check
elevator
hinges
for
condition,
cracks
and
security.
Inspect
hinge
bolts,
hinge
bearings,
torque
tube,
horn
and
attach
fittings
for
evidence
of
damage
or
wear.
Check
travel
and
friction.
*50-Hour
Requirement,
Refer
to Paragraph
5-22,
B.
Page 5 of 9