The break-in period for your new ATV is defined as twenty first ten hours of operation, or the time it takes to
use the first four full tanks of gasoline. No single action on your part is as important as following the
procedures for a proper break-in. Careful treatment of a new engine will result in more efficient performance
and longer life for the engine. Perform the following procedures carefully.
Excessive heat build-up during the first three hours of operation will damage close-fitted engine parts. Do
not operate at full throttle or high speeds for extended periods during the first three hours of use.
Use of any oils other than those recommended may cause serious engine damage. We recommend the use of
4 Synthetic Oil for your 4-cycle engine.
1. Fill the fuel tank with gasoline.
2. Check the oil level on the dipstick.
Add 4 Synthetic Oil if necessary to maintain the oil level between the minimum and maximum level marks.
3. Drive slowly at first. Select an open area that allows room to familiarize yourself with vehicle operation and
handling.
4. Vary throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined on the daily pre-ride inspection checklist.
See page 58.
To Next Page