Always check and change the engine oil at the intervals
outlined in the Periodic Maintenance Chart beginning on
page 83. Always change the oil filter whenever changing oil.
1. Pull outward on the areas shown .
2. Position the ATV on a level surface.
3. Start the engine and let it idle for 20-30 seconds. Stop the
engine.
4. Wait a few minutes until the oil settles.
5. Remove the engine oil filler cap and wipe off the
dipstick with a clean rag.
6. Insert the dipstick in the oil filler hole and screwing it in,
then remove it again to check the oil level.
The engine oil should be between the upper and
lower limit marks.
To Next Page