7. Apply a light coat of engine oil to the O-ring of the new oil
filter cartridge.
Make sure the O-ring is seated properly.
8. Install the new oil filter cartridge with an oil filter wrench, and
then tighten it to the specified torque with a torque wrench.
Oil filter cartridge tightening torque: 17 N m (1.7
m kgf, 12 ft lbf)
10. Install the engine oil drain bolt, and then tighten it to the specified torque.
Engine oil drain bolt tightening torque: 30 N m (3.0 m kgf, 22 ft lbf)
11. Add the specified amount of recommended engine oil, and then install the engine oil filler cap and tighten it.
Without oil filter cartridge replacement oil quantity: 1.8 L (1.58 Imp qt, 1.90 US qt)
With oil filter cartridge replacement oil quantity: 1.9 L (1.67 Imp qt, 2.01 US qt)
12. Start the engine and warm it up for several minutes. While warming up, check for oil leakage. If oil leakage
is found, turn the engine off immediately and check for the cause.
13. Turn the engine off, and then check the oil level and correct it if necessary.
To Next Page