CP30 User Manual
3.6 Basic Function
3.6.1 Power On/ Power Off
Make sure the printer is connected to power.
When the printer is off, press the power button once, and printer will power on.
When the printer is on, press the power button for three seconds. After ringing twice, the printer
will power off.
3.6.2 FEED Button
When the printer is ready, press the feed button, and printer will automatically feed a label under
“Label Mode”. Press the feed button, and the printer will feed the fixed distance under
“Continuous Mode”.
When the printer is printing, press the feed button once and it will stop the printing job. Press the
feed button for three seconds and it will cancel the printing job.
When the printer pauses, press the feed button once and it will continue the printing job. Press the
feed button for three seconds and it will cancel the printing job.
When the printer is in dump mode, press the feed button once, then back to the normal printing
mode.
When the indicator status flashes slowly(green), press the feed button once and printer will print a
label.
3.6.3 Quick Calibration
Users must carry out the calibration under the conditions below:
The first time to use the printer since installation;
The first time to use the printer since sensor cleaning;
Reuse the printer when it has not been used for a long time;
Change a new type of media;
Printer cannot recognize the mark;
Huge change of the operating environment.
Calibration method:
1.Carry out the calibration manually.
The printer is connected to the power supply and the paper roll is installed correctly.
Confirm that the printer top cover and the printer mechanism have been closed in place, and the
printer is powered on.
When printer is ready, press the FEED button for 3 seconds until the status indicator(Green)
To Next Page
Loading...