CP30 User Manual
flashes twice. Then release the button, and printer will start to do the calibration. When printer
does the calibration under Continuous Media Mode, the calibration is invalid.
2.Carry out the calibration by printer utility tool.
Note: After the quick calibration, users could open the printer cover to pull back the learned
paper in avoid of paper wasting.
3.6.4 Print Self-test Page
The self-test checks the printer’s current settings, status and whether the printer has any problems or
not.
1.Printing Manually
Make sure the roll is loaded properly.
Make sure the top cover of the printer is closed properly. Then turn on the printer.
When the printer is ready, press the feed button continuously. As soon as the indicator flashes (green)
once, loosen the button. Then the printer starts to print the self-test page.
2.Printing by Windows Driver Program
Install the Windows Driver program.
Set the “Interface” as the type you use.
Use the Windows Driver Program to print out the “Self-test page”.
To Next Page
Loading...