23
STABILIZER JACKS
All models except the LTW base come
standard with four stabilizer jacks, one on each
of the four corners. The jack is designed for
fine leveling and stabilizing light weight
trailers with up to 14” of clearance from frame
to ground. Please refer to the data sheet
included in your appliance packet for safety
warnings and operating instructions.
• If soil condition is soft, be sure to use
some type of block or support under
the jack foot.
• Always level the trailer from side to
side and front to back. Once the trailer
is positioned and level, chock wheels
so trailer will not shift.
• DO NOT attempt to use this stabilizing
jack for jacking purposes or to support
the full weight of the trailer.
• Use only the crank handle provided.
• DO NOT attempt to use this stabilizing
jack for any purpose other than its
intended design.
• DO NOT attempt to move the trailer
unless the stabilizer jacks are fully
retracted. Failure to do so may result in
damage to one or more of your
stabilizer jacks.
To Next Page
Loading...