11
The machine is intended for drilling in wood, metal,masonry,ceramic,plastic, as well as
for screwdriving purposes. This tool is intended for consumer use only.
Intended Use
Recharging Batteries
Before using the tool , read the instruction book carefully.
Note
Warning: The charger and battery pack are specifically designed to work
together so do not attempt to use any other devices. Never insert or allow metallic
objects into your charger or battery pack connections because an electrical failure
and hazard will occur.
Charging your batt ery pack
Your battery pack is UNCHARGED and you must charge once before use.
Your battery pack will not be fully charged until you have performed several
charge and discharge operations by charging & working with your drill.
After this your battery pack performance will improve.
Before using your cordless drill
Insert the charger adapter (a) into a suitable mains socket and the red light (b) will
illuminate. Insert the battery pack into the charger base(d). The green light (c) will on
and the red light (b) will remain on. A discharged battery at normal ambient
temperature will take approximately 3-5 hours to reach full charge. When charging
is complete, unplug the charger and remove the battery pack.
Note:
The charger will not automatically switch off when the battery is full charged. Both
the green light and the red light indicator will remain on. Do not leave your battery on
charge continuously. This may damage the battery cells.
Do not charge the battery for more than 10 hours.
WARNING: After long usage the battery will become hot. Let the hot battery cool
down for at least 0.5 hour before recharging.
To charge the battery (See Fig. A1)
Customer Helpline 0345 640 0800
To Next Page
Loading...
Need help?
General
