Challenge Xtreme BMS210MS.1 User Manual

HELPLINE NO 08448012949
16
ORIGINAL INSTRUCTIONS
procedure in reverse order. If you want to
take the inner ange out for cleaning, ret it
as shown in Fig.P4
CAUTION: ALWAYS install the blade with
the blade teeth and the arrow printed on the
side of the blade pointing down at the front
of the saw. The direction of blade rotation
is also stamped with an arrow on the upper
blade guard.
Fig. P4
3. REPLACING THE CARBON BRUSHES
Check the carbon brushes regularly. If the
carbon brushes are worn down to about
4mm, replace them with the new set (not
supplied). It must be replaced in pairs.
With a suitable slotted screwdriver turn the
cap anti-clockwise until the carbon brush is
released, replace the brush and make sure
that they locate well and are secured within
the brush retainer.
4. MOVING THE SAW (See E1)
1) When transporting the saw with xed
locations, make sure that the saw head is
locked in the lower position.
2) The rotary table locking knob, the bevel
lock lever and the slide rod securing knob,
must all be securely tightened.
3) Use the transportation handle to lift
the saw. Do not lift the saw by the switch
handle.
PLUG REPLACEMENT
Your Power Tool is supplied with a tted
plug, however if you need to t a new plug
follow
the instruction below.
IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
Blue = Neutral Brown = Live
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked
with N.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L .
If a 13 AMP (BS 1363/A) Plug is used, a
13 AMP Fuse must be tted, or if any other
type of plug is used a 13 AMP Fuse must
be tted, either in the Plug or Adaptor, or
on the Distribution Board.
NOTE: If a moulded plug is tted and has
to be removed take great care in disposing
of the plug and severed cable, it must
be destroyed to prevent engaging into a
socket.
If the supply cord is damaged it must be
replaced by a service agent or a similarly
qualied person in order to avoid hazard.

Challenge Xtreme BMS210MS.1 Specifications

General

Brand	Challenge Xtreme
Model	BMS210MS.1
Category	Saw
Language	English