HELPLINE NO 08448012949
7
ORIGINAL INSTRUCTIONS
TECHNICAL DATA
Type BMS210MS(MS -designation of machinery, representative of Mitre Saw)
Rated voltage 220-240V~50Hz
Rated Input power 1400W S1 / 1700W S6 25%
No load speed 5000/min
Bevel capacity 0-45º
Mitre capacity 0-45º
Blade size 210mm
Protection class
/II
Machine weight 15kg
NOTE: The tool is designed under the power input S1 continuous operation or S6 25%
10min continuous operation periodic duty, 7.5 min use on no load after 2.5 min use at
constant load. (load time/cycle time x 100%=2.5/10=25%) The tool can only be used
under such operation conditions to avoid breaking the tool.
CUTTING CAPACITY:
Mitre/Bevel: 0
°/90° 305x60mm
Mitre/Bevel: 0
°/45° 305x35mm
Mitre/Bevel: 45
°/90° 210x60mm
Mitre/Bevel: 45
°/45° 210x35mm
NOISE/VIBRATION INFORMATION
A weighted sound pressure 100dB(A)
A weighted sound power 113dB(A)
Wear ear protection when sound pressure is over 80dB(A)
Typical weighted vibration 4.51m/s
2
Uncertainty K=1.5m/s²
WARNING: The vibration emission value during actual use of the power tool can
differ from the declared value depending on the ways in which the tool is used
dependant on the following examples and other variations on how the tool is used:
How the tool is used and the materials being cut.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions
of use should also take account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle but not actually doing the job. This
may signicantly reduce the exposure level over the total working period.
Helping to minimize your vibration exposure risk.
ALWAYS use sharp blades
To Next Page
Loading...
Need help?
General
