Challenge Xtreme CX-TS 800 - Page 9

Helpline No 0844 801 8701 / IRE 189 094 6244
7
fitted before the machine is switched on.
• Itmustbepossibleforthebladetorunfreely.
• Whenworkingwithwoodthathasbeenprocessed
before, watch out for foreign bodies such as nails
or screws etc.
• BeforeyouactuatetheOn/Offswitch,makesure
that the saw blade is correctly fitted and that the
machine’s moving parts run smoothly.
• Followtheinstructionsforlubricationandchanging
tools.
• Keephandlesdry,cleanandfreefromoiland
grease.
• Keepthepushstickorhandleforapushblockat
the machine at all times, even when you are not
using them.
• Donotcutrebatesorgrooveswithoutfittinga
suitable guard, e.g. a tunnel-type guard, over the
saw table.
• Useonlythetransportdevicefortransportingthe
machine.
• Whileyouaremovingthemachineitisbestto
cover the top part of the blade, for example using a
guard.
Do not lose these safety instructions.