SAFETY
A-10 547095D1 C Rev
Filler cap must be cool enough to touch with a bare hand.
Follow the standard procedure in this manual to remove
hydraulic tank and transmission filler caps.
Lines, Tubes and Hoses
Do not bend or strike high pressure lines. Do not install
any lines bent or damaged.
Repair any loose or damaged lines. Leaks can cause
fires. Consult your dealer for repair or for replacement
parts.
m
DANGER: Diesel fuel or hydraulic fluid
under pressure can penetrate the skin or
eyes and cause serious personal injury,
blindness, or death.
Fluid Penetration
FIG. 7: Always use a board or cardboard when checking
for a leak. Leaking fluid under pressure can penetrate
body tissue. Fluid penetration can cause serious injury
and possible death. A pin hole leak can cause severe
injury. If fluid is injected into skin, get treatment
immediately. Seek treatment from a doctor familiar with
this type of injury.
Check lines, tubes and hoses carefully. Do not use your
bare hand instead, use a board or cardboard to check for
leaks. Tighten all connections to recommended torque.
Replace the parts if any of the following conditions are
present:
• End fittings are damaged or leaking.
• Outer coverings are chafed or cut.
• Wires are exposed.
• Outer coverings are ballooning.
• Flexible part of hoses are kinked.
• Outer covers have embedded armoring.
• End fittings are displaced.
IMPORTANT: Care must be taken to ensure that fluids
are contained during performance of inspection,
maintenance, testing, adjusting, and repair of
machine. Be prepared to collect the fluid with
suitable containers before opening any
compartment or disassembling any component
containing fluids. Dispose of all fluids according
to local regulations and mandates
FIG. 7
To Next Page
Loading...
Need help?
General
