Chamberlain 050DCTWFLK - User Manual

1
Before you begin
1
Installation
RECEIVER LOGIC BOARD REPLACEMENT
Model 050DCTWFLK
1.2 To maintain your warranty,
place the provided label
over the existing label
on the end panel of the
garage door opener.
1.1 Remove the light lens by pulling
the top sides of the light lens
and rotate the light lens down.
Squeeze the light lens clips to
remove lens from end panel.
1.3 Disconnect electrical and battery
power (if applicable) to the
garage door opener.
Remove the receiver logic board
2
2.1 Disconnect the wires from the quick-connect terminals
(A). Disconnect any wires from the lock terminals.
Remove the receiver logic board end panel from the
garage door opener.
2.2 Unplug the wire harnesses from the receiver logic
board. You may need needle-nosed pliers, to
remove the harnesses.
2.3 Remove the receiver
logic board from the
end panel by removing
the 2 screws and
releasing the 2 clips.
To prevent possible SERIOUS INJURY or DEATH:
• Disconnect ALL electric and battery power BEFORE performing ANY
service or maintenance.
Screws
Wire clip
Clips
A
To insert or remove the wires from the terminal,
push in the tab with a screwdriver tip.
Lock
Terminals
Red White White Grey
Your garage door opener has an internal gateway located on the receiver logic board. After installing the new receiver logic board, use the MyQ
®
serial number found on the provided label to add your
garage door opener to your MyQ
®
account. The products illustrated in the instructions are for reference. Your product may look different.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm. For more information go
to www.P65Warnings.ca.gov
To prevent damage to the receiver/logic board, DO NOT touch printed
circuit board of replacement receiver/logic board during installation.
ALWAYS wear protective gloves and eye protection when changing the
battery or working around the battery compartment.

Summary

Installation Guide

Before You Begin

Essential preparatory steps and safety precautions before starting receiver logic board replacement.

Remove Receiver Logic Board

Detailed instructions on disconnecting wires and removing the existing receiver logic board from the opener.

Install New Receiver Logic Board

Connect and Install Logic Board

Steps for connecting wire harnesses, inserting antenna wires, securing the new logic board, and reinstalling the light lens.

Programming and Adjustment

Program Remote Control

Guide to program a remote control using the learn button and indicator light on the garage door opener.

Program Travel Limits

Instructions for setting the garage door's up and down travel limits, including safety warnings.

System Testing and Synchronization

Test Safety Reversal System

Procedure to test the safety reversal system using a 1-1/2 inch object for obstruction detection.

Test Protector System

Procedure to test the protector system by obstructing the safety reversing sensor.

Synchronize Door Control

Steps to synchronize the door control to the garage door opener using the push bar.

Chamberlain 050DCTWFLK Specifications

General

Brand	Chamberlain
Model	050DCTWFLK
Category	Receiver
Language	English