36
Operation
Remote Control (continued)
PROGRAM USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Pressand immediately release the Learn button.The Learn LED will glow steady for 30
seconds. Within 30 seconds...
3. Remote Control: Press and hold the button on the remote control that you wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keylessentry keypad.Then press and hold the ENTER button.
Release the button when the garage door opener lightsblink or two clicksare heard. When replacing
the light lenscover, ensure the antenna wiresare hanging straight down.
LEARN LED
LEARN
Button
“click”
“click”
1-2 3
PIN
To watch a video, go to tinyurl.com/lcsf6xt
HomeLink
®
If your vehicle isequipped with HomeLink,a Compatibility Bridge
TM
(notincluded) maybe necessary for
certain vehicles.Visit bridge.chamberlain.com to find out if a Bridge is needed.
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Pressand hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).All remote control and keylessentrycodes are now erased.
Reprogram anyaccessory you wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Pressand hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately pressand hold the LEARN button again until the learn LED goes out.All codes
are now erased.Reprogram any accessoryyou wish to use.
To Next Page
Loading...
