To Next PageTo Next PageWhat to do if Chamberlain Elite CSW200101U main control board fails?
If the main control board of your Chamberlain Gate Opener fails, try these steps: First, disconnect all power to the unit. Wait for 15 seconds, and then reconnect the power to reboot the system. If the problem persists after rebooting, the main control board likely needs to be replaced.
General| Type | Swing Gate Opener |
|---|---|
| Power Supply | AC |
| Voltage | 120V |
| Max Gate Weight | 1000 lbs |
| Max Gate Length | 20 ft |
| Remote Control | Yes |
| Warranty | 5 years |
| Motor Type | DC |
| Remote Controls Included | 2 |
| Frequency | 315 MHz |
| Safety Features | Obstruction Sensing, Auto-reverse |
| Drive System | Chain Drive |
| Smart | MyQ enabled |
Details entrapment protection requirements for gate operators.
Details technical specifications, including dimensions for models.
Guides on selecting the optimal location for the gate operator.
Provides charts and dimensions for determining operator location.
Instructions for mounting the gate operator onto the concrete pad or post.
Explains the installation of safety entrapment protection devices.
Instructions for installing the earth ground rod for safety.
Details the process of connecting the power wiring to the operator.
Guides on connecting the operator to the main power supply.
How to test the gate's obstruction sensing feature.
Details wiring options for entrapment protection devices.
Instructions for setting up wireless communication for dual gates.
Instructions for setting up wired communication for dual gates.
Guides on setting gate direction and travel limits.
Procedure for setting the gate's opening direction (left/right).
Procedure for configuring the gate's open and close travel limits.
Procedure for setting the operator's force and run distance.
Details how to adjust the gate's force setting.
Explains the operator type, firmware version, and codes shown on the display.
How to use test buttons for gate operation and code viewing.
Wiring photoelectric and edge sensors to the expansion board.
Comprehensive diagram for field wiring connections.
Instructions for programming remote controls to the operator.
Recommended settings for dual gate operation.
Crucial safety precautions before performing maintenance.
General instructions for disconnecting power before maintenance.
Lists and explains various diagnostic codes and their meanings.
A table of common symptoms, causes, and solutions.
Continues the table of symptoms, causes, and solutions.
