33
Operation
Using your Garage Door Opener
The garage door opener can be activated through a wall-mounted door control, remote control, or
wirelesskeyless entry.
When the door is closed and the garage door opener is activated the door will open. Ifthe door senses
an obstruction or is interrupted while opening the door will stop. When the door is in anyposition other
than closed and the garage door opener is activated the door will close.Ifthe garage door opener
sensesan obstruction while closing, the door will reverse.If the obstruction interrupts the sensor beam
the garage door opener lightswill blink10 times.However,you can close the door if you hold the button
on the door control or keylessentry until the door is fully closed. The safety reversing sensors do not
affectthe opening cycle.
The safetyreversing sensor mustbe connected and aligned correctly before the garage door opener will
move in the down direction.
Using the Push Button Door Control
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control to the garage door opener,
press the push button until the garage door opener activates (itmay take up to 3 presses).
Remote Control
Your remote control has been programmed at the factory to operate with your garage door opener.
Older Chamberlain remote controls are NOT compatible, see page 38 for compatible accessories.
Programming can be done through the door control or the learn button the garage door opener. To
program additional accessories refer to the instructions provided with the accessoryor visit
www.chamberlain.com.Ifyour vehicle is equipped with HomeLink
®
, a Compatability Bridge
TM
(not
included) may be necessary for certain vehicles. Visitbridge.chamberlain.com to find out ifa Bridge is
needed.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
1. Pressand immediately release the Learn button.
2. Remote Control:
Press and hold the button on the remote control that you wish to use.
Keyless Entry:
Enter a 4-digitpersonal identification number (PIN) of your choice on the keyless entry keypad.
Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code hasbeen
programmed. Repeat the steps for programming additional remote controls or keyless entrydevices.
1
2
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
Q
Z
*
#
E
NT
E
R
0
“click”
“click”
LEARN LED
LEARN
Button
To Next Page
Loading...
