20
Installation
STEP10 Install the door control
To prevent possible SERIOUS INJURY or DEATH from electrocution:
l Be sure power is NOT connected BEFORE installing door control.
l ConnectONLY to 12 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
l Install door control within sight ofgarage door,out ofreach of children at a minimum heightof 5
feet (1.5 m),and away from ALL moving parts of door.
l NEVER permit children to operate or play with door control push buttons or remote control
transmitters.
l Activate door ONLY when it can be seen clearly,is properly adjusted, and there are no
obstructions to door travel.
l ALWAYS keep garage door in sight until completely closed.NEVER permitanyone to cross path
of closing garage door.
INTRODUCTION
Install the door control within sight ofthe door at a minimum heightof 5 feet(1.5 m) where small children
cannotreach,and away from the moving parts of the door.
NOTE: Your product may look different than the illustrations.
1. Strip 1/4" (6 mm) ofinsulation from one end ofthe wire and separate the wires.
2. Connectone wire to each of the two screwson the back of the door control. The wires can be
connected to either screw.
3. Mount the door control with the hardware provided.
To Next Page
Loading...
