Chamberlain HD220 User Manual

The Chamberlain Group, Inc.
845 Larch Avenue
Elmhurst, Illinois 60126-1196
www.chamberlain.com
CONTENTS
Preparation .............................. 1-4
Assembly ................................. 5-9
Installation ............................ 10-17
Install the Door Control ............. 18-19
Install the Protector System
®
...... 20-23
Power .................................. 24-25
Adjustments .......................... 26-28
Operation.................................. 29
Features ................................... 30
Remote Control .......................... 31
To Erase the Memory .................... 32
To Open the Door Manually ............ 32
Maintenance .............................. 33
Diagnostic Chart ......................... 34
Warranty .................................. 35
Chain Drive
Garage Door Opener
■ Please read this manual and the enclosed safety materials carefully!
■ Fasten the manual near the garage door after installation.
■ The door WILL NOT CLOSE unless the Protector System
®
is connected and
properly aligned.
■ Periodic checks of the garage door opener are required to ensure safe operation.
■ The model number label is located on the back panel of your garage door opener.
■ This garage door opener is compatible with Security✚ 2.0™ accessories.
Serial Number:
Date of Purchase:
Model Number:
Models HD220, HD220C,
PD220, PD222, LW260C,
and LW2200
FOR RESIDENTIAL USE ONLY
INSTALL ON 7 FOOT
SECTIONAL DOORS ONLY
Register your new garage door opener at
www.prodregister.com/chamberlain or
scan the QR code with your smartphone
Write down the following information
for future reference:

Chamberlain HD220 Specifications

General

Type	Chain Drive
Horsepower	1/2 HP
Max Door Height	7 feet
Drive System	Chain
Safety Features	Safety sensors
Voltage	120V AC
Motor Type	AC
Security	Rolling Code Technology
Battery Backup	No
Wall Console	Included
Wi-Fi Compatibility	No
Drive Type	Chain

Summary

Preparation

Safety Symbol and Signal Word Review

Explains safety symbols and signal words used in the manual for safety.

Check the Door

Guide to checking garage door balance and condition before installation for safety.

Assembly

Step 1 Assemble the Rail and Trolley

Instructions for assembling the rail and trolley components.

Step 2 Fasten the Rail to the Motor Unit

Steps to securely attach the assembled rail to the motor unit.

Step 3 Install the Pulley

Step 4 Install the Chain

Step 5 Tighten the Chain

Installation

Important Installation Instructions

Crucial safety warnings and guidelines before starting installation.

Step 1 Determine the Header Bracket Location

Step 2 Install the Header Bracket

Step 3 Attach the Rail to the Header Bracket

Step 4 Position the Garage Door Opener

Step 5 Hang the Garage Door Opener

Step 7 Attach the Emergency Release Rope and Handle

Step 8 Install the Door Bracket

Step 9 Connect the Door Arm to the Trolley

Step 10 Install the Door Control

Step 11 Wire the Door Control to the Garage Door Opener

Step 13 Install the Protector System®

Instructions for installing the safety reversing sensors.

Step 14 Wire the Safety Reversing Sensors

Guide for wiring safety sensors without pre-wiring.

Step 15 Connect Power

Instructions for connecting the opener to a power source.

Step 16 Aligning the Safety Reversing Sensors

Steps to align safety sensors for proper operation.

Adjustments

Introduction

Step 1 Program the Travel

Detailed procedure for setting the door's open and close travel limits.

Operation

Important Safety Instructions

Comprehensive safety warnings for operating the garage door opener.

Using Your Garage Door Opener

Remote Control

To Open the Door Manually

Troubleshooting

Diagnostic Chart

A chart listing diagnostic codes, symptoms, and solutions for common issues.