2
Additional Items You May Need:
Surveyyour garage area to see if you will need any of the following items:
n
(2) 2X4 PIECES OF WOOD
Maybe used to fasten the header bracket to the structural supports. Also used to position the
garage door opener during installation and for testing the safetyreversing sensors.
n
SUPPORT BRACKET AND FASTENING HARDWARE
Must be used if you have a finished ceiling in your garage.
n
EXTENSION BRACKETS (MODEL 041A5281-1) OR WOOD BLOCKS
Depending upon garage construction, extension bracketsor wood blocks maybe needed to
install the safetyreversing sensor.
n
FASTENING HARDWARE
Alternate floor mounting of the safetyreversing sensor will require hardware notprovided.
n
OUTSIDE QUICK RELEASE (MODEL 7702CB)
Required for a garage with NO access door.
n
DOOR REINFORCEMENT
Required if you have a lightweight steel, aluminum, fiberglassor glass panel door.
n
RAIL EXTENSION KIT
Required if your garage door is more than 7 feet(2.13 m) high.
Tools Needed
2
1
3/16
7/16
1/2
7/32
5/16
3/8
7/16
1/2
Preparation
To Next Page
Loading...
Need help?
General
