To Next PageTo Next Page
Need help?Do you have a question about the Chamberlain RollerLift CR655MYQ and is the answer not in the manual?
General| Smartphone Control | Yes |
|---|---|
| Voice Control | Yes |
| Drive System | Chain Drive |
| Connectivity | Wi-Fi |
| Security | Rolling Code |
| Remote Control | 2 x 3-Button Remote Controls |
Includes instructions on compliance, door balance, attire, inspection, rope removal, and wiring.
Covers safe operation, including use of Protector System, wall control placement, child safety, and power disconnect.
Details maximum door height, area, mass, and axle diameter for compatibility.
Specifies the need for the Protector System if closing force exceeds 400N (40 kgf).
Details connections for external accessories via the terminal block.
Explains the function of UP, DN, P, S buttons and the purpose of LEDs 1, 2, and 3.
Describes the main Control Button for manual activation and the Courtesy Light.
Procedure to test door balance, checking for sticking or binding points.
Instructions for installing the stop collar on the door shaft.
Guidance on attaching the weight bar to the door for balance.
Method to remedy door ballooning by securing curtain to drum wheel.
Instructions for threading and adjusting the manual release cord and handle.
Steps to disengage and re-engage the opener using the release cord.
Steps before mounting, including manual mode, securing door, and bracket removal.
Instructions for sliding opener onto axle, refitting bracket, and clamping.
Steps for connecting the power cable and turning on the opener.
Configure opener for right or left hand installation using 'P' and 'S' buttons.
Set desired OPEN and CLOSED positions using UP/DN buttons and 'P' to accept.
Configure force automatically or manually using UP/DN buttons and 'P'/'S' buttons for adjustments.
Test door reversal with a 40mm obstacle; repeat settings if necessary.
Guidance on positioning risk of entrapment and WARNING labels.
Activate/deactivate TTC for 10-180 seconds, requires Protector System.
Program transmitters to operate the garage door opener light.
Instructions to turn the audible 'BEEP' ON or OFF.
Set an adjustable second stop position for ventilation, programmed to transmitter.
Program additional transmitters using the 'S' SAVE Button.
Erase all transmitter codes by holding the 'S' button.
Opener activation, obstruction handling, and steps for manual release.
Monthly maintenance, limit/force checks, and technical opener specifications.
Typical wiring diagram showing connections for opener accessories.
Instructions and safety precautions for replacing transmitter batteries.
Troubleshooting steps for when the opener fails to operate.
Resolving problems like door not closing, reversing, or motor humming.
Interpreting LED codes and guidance for power failure scenarios.
List of optional accessories for the opener.
Interprets fault codes indicated by LED flashes with symptoms and resolutions.
Details warranty period, what is covered, and conditions like door balance and servicing requirements.
Lists exclusions that void the warranty and the procedure for making a warranty claim.
Covers warranty for accessories and provides contact details for service centres.
