LiftMastefr
APPTICATIOI{
The
STAR1000
is
a
high
capacity
single channel commercial access
control
receiver lor
commercial
door operators, and dry contact
triggered
devices. The STAR1000
is
compatible
with Security* 2.OTM remote
controls
and
wireless keyless entries, Security*
2.0TM Passport and
Passport Lite remote
controls.
This
receiver is
compatible
with
HomeLink@. For
programming
or compatibility
information visit
www.homelink.com.
The
receiver
capacity
is
1,000 devices and can be
any combination of
remote
controls
and wireless
keyless
entries.
The
receiver is watertight
according
to
lPX44
specification.
I{STAU.AT|0l{
1. Select a convenient
location near the operator
to be controlled by the
receiver within
"line
of sight"
of the intended
transmitting location.
NOTE: Do not mount LCD screen
in direct sunlight.
Avoid nounting
the receiver in a metal enclosure or
near other wireless
receiving
or
transmitting
devices.
2. Mount the bracket to
the
desired
surface with appropriate
hardware
(not
provided)
(Figure
l
).
3.
Remove
the
4
(#8)
screws on
the
back of
the receiver and
remove the
faceplate. Unplug the keypad
connector from
the control board.
N0lE: Be careful not to damage
the keypad cable
while removing the
faceplate.
4. Make wiring
connections
(Figure
2). Reter to
your
gate
or commercial
door
operator
owner's
manual for more specific
information.
5.
Beconnect the keypad connector
to the board
(labeled
J9).
6. Secure
the faceplate
with the 4
(#8)
screws
previously
removed.
7. lnstall the antenna
provided.
NOIE:
Use
the optional 86LM
or 86LMT
antenna extension
kit
(see
page
4) to mount the
remote antenna as
high and
far from
metallic objects as
possible
lor
best
radio range.
8. Snap the
receiver onto the
mounting bracket and
secure
with the
(#8)
screws
provided.
9.
Tighten the watertight connector
t0 secure and
seal
the wiring.
GOMMERGIAT
AGCESS
COilTROt
REGEIUER
MODEL
STAR|OOO
AAWARNING
To
prevent possible
SERI0US INJURY or DEATH trom electrocution:
.
Be
sure
power
is NOT
connected
BEF0RE installing the receiver.
To
prevent possible
SERI0US
INJURY or DEATH from a moving
gate
or
garage
door:
.
ALWAYS keep
remote
controls out of
reach
of children.
NEVER
permit
children
t0
operate, or
play
with remote
control
transmitters
.
Activate
gate
or door 0NLY when
it
can be seen clearly,
is
properly
adiusted, and
there
are
no
obstructions
to door travel.
.
ALWAYS keep
gate
or
garage
door
in
sight
until
completely closed.
NEVER
permit
anyone to
cross
path
ol moving
gate
or door.
A
WARNING
To
prevent
possible
SERI0US
INJURY or DEATH, the use of
C0NSTANT 0PERATI0N on
residential openers
is
PROHIBITED.
When a
receiver is
used
to
activate a commercial door
opener,
a
reversing
edge
MUST
be
installed
on
the bottom ofthe door. Failure to
install a reversing edge under these circumstances
may result in
SERI0US
INJURY
or
DEATH to
persons
trapped beneath the door.
Figure 1
N
Connection
Power
Conn€ction
I
-
30 volts
AC/DC
250 mA
max
Power
Supply
Single
Operator
To Next Page
Need help?
General
