To Next PageTo Next PageWhat to do if my Champion DH6000 Dishwasher will not drain?
If your Champion Dishwasher is not draining, start by cleaning the drain screen. If that doesn't solve the problem, the drain valve may be defective, in which case you should contact a service agent, or manually open the drain valve to drain. Additionally, check if the building drain is clogged and contact Building Maintenance if needed.
How to troubleshoot a Champion DH6000 that will not run and the HMI is unresponsive?
If your Champion Dishwasher won't run and the HMI is unresponsive, make sure the hood is completely closed and the door switch is working correctly. Check the breaker on the panel, and select a 1, 2, 4, or 6-minute cycle. The issue might also be a bad pump or contactor, a power outage, or a tripped overload.
What to do if there is low or no water in my Champion Dishwasher?
If your Champion Dishwasher has low or no water, first ensure that the main water supply is on and the supply valve is open. Then, check the PRV setting and set it to 20-22 PSI flowing. If problems persist, there might be a clogged line strainer or a defective valve of float, in which case you should contact a service agent.
Why are the Champion DH6000 wash results poor?
Poor wash results with a Champion Dishwasher can stem from several issues. First, ensure that wares are correctly loaded in the dish rack, repositioning them or reducing the amount if necessary. Check and clean clogged screens and spray arms. Verify that chemical injectors are feeding properly and repair any leaks in the detergent pump hose. If the water temperature is below 55°F for VHR, contact a service agent to increase the water temperature to 75°F.
Why are chemicals not feeding into my Champion DH6000?
If chemicals aren’t feeding into your Champion Dishwasher, first refill the chemical container. If the issue persists, rinse the pick-up tube with warm water, replace any damaged supply tubing, and straighten any kinked tubing. Also, check the chemical containers and replace the squeeze tube if it's worn.
Why is there excessive steam escaping from the Champion DH6000's Heat Recovery System?
If you observe excessive steam escaping from the Heat Recovery System of your Champion Dishwasher, check the incoming cold water temperature and ensure it is not above 75°F. Also, verify that the incoming water pressure is at least 45 PSI. Check the machine level. For issues with the recovery coil or fan, contact a service agent.
General| Water Inlet | 3/4" NPT |
|---|---|
| Color | Stainless Steel |
| Voltage | 208-240V |
| Phase | 1 |
| Drain Outlet | 1-1/2" NPT |
| Water Consumption | 0.74 gallons per rack |
