ChamSys MQ100 Series - Page 6

ChamSys MQ100 Series Service Document
Page 6 of 22 www.chamsys.co.uk
DC Card for Pro2014 Series Consoles:
The Pro2014 is the final iteration of the MQ100 consoles, including an updated rear panel
and DC card. This updated DC card has slightly different connections to the original DC
cards, as listed below.
A. Back panel USB connections
B. USB connection for Front arm rest USB
C. Wing connections for MQ200 and MQ300 consoles
D. Power input connectors for DC card
E. Processor power connector
F. Front Panel cable
G. Front Panel LVDS Display signal cable
Note: The connectors used on sockets C and D indicated above use the same 6 pin
latching connector. Care must be taken to ensure the console PSU is connected only as
shown to the socket labelled D in the picture above. Connecting the PSU cable to the
wing sockets on the back end of the PCB can cause serious damage, resulting in a return.
A
B
C
D
E
F
G