When installing the new brush plate, make sure that the flange plate is aligned with the holes on the brush plate, and rotate it
in any direction to finish the installation.
Installation of the needle plate: add a scouring pad on the bottom of the needle plate, and install it following the instructions
above. You can purchase needle plates and scouring pads from the original manufacturer.
The scouring pad must be soaked in water for 10-15 minutes before use, otherwise it will damage the ground.
5.2.2 Replacement of the strip of the squeegee
Park the machine on the flat ground and make sure that it is powered-off.
Use the squeegee lifting handle to put down the squeegee and screw the plastic handle counterclockwise to remove the
squeegee holder.
Unscrew the nuts of the squeegee holder and remove its bottom plate; remove the front and rear strips of the squeegee.
Install the new strips.
To Next Page
Loading...