CHANCEE K68 - Adjustment Items

3.1.4 Checking the degree of wear of the brush plate
 Check whether the brush plate is worn. If so, adjust the height of the brush plate or replace it.
3.1.5 Checking the degree of wear of the strip
The strip needs to be replaced if:

the strip cannot touch the ground when the squeegee is put down, or

the strip is cracked.
3.2 Adjustment items
3.2.1 Adjustment of the squeegee holder
 Use the nuts on the universal wheels to lift or lower the squeegee holder.
3.2.2 Adjustment of the squeegee holder

Put down the squeegee holder to see whether the strip touches the ground.

Push the machine gently to see whether the strip is slightly bent and leaves no gap between itself and the ground.

If there is any gap between the strip and the ground or the strip is pressed too tight, use the universal wheels on the squeegee
holder to adjust its position.