4.1 Walking of the machine
Turn on the general switch.
Turn the forward/backward button to the forward gear and step on the accelerating pedal, and then the machine will move forward.
Turn the forward/backward button to the backward gear and step on the accelerating pedal, and then the machine will move backward.
If you need to stop the machine, just release the accelerating pedal so that the electromagnetic brake will work automatically
and the machine will be stopped.
Note: when the machine is moving backward or needs to be transported, make sure that the brush plate and the squeegee
are lifted, or the brush plate will be worn and the squeegee will be deformed.
4.2 Scrubbing the floor
Put down the brush plate and the squeegee.
Turn on the general switch.
Press the brush plate button and the suction motor button.
Turn the forward/backward button to the front gear, hold the steering wheel, step on the accelerating pedal and drive the
machine smoothly.
Note:
When the brush plate motor is turned on, do NOT leave the machine in the same place for a long time, because this would
leave unnecessary marks on the ground.
4.3 Discharging sewage
Before discharging the sewage tank, stop the machine and turn off the general switch.
Put down the sewage discharging pipe, open the cap and discharge the sewage.
Use clean water to wash the sewage tank.
4.4 Stopping the machine
When the work is finished, turn off the brush plate button and lift the brush plate.
Turn off the suction motor and lift the squeegee.
Discharge the sewage tank.
Move the machine to an appropriate storage place.
Turn off the general switch and remove the key.
Note: if the machine is not about to be used for a long time, please fully charge the batteries, disconnect the battery cords to
avoid power loss.
To Next Page
Loading...