8
O = OFF I = ON
O NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
IQUID VACUUMING
from the outlet.
D
\\
LI
UID
ACUUM OPERATION
L
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED ‘SAFETY
INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT
LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
1. Verify that the power cord is disconnected from the outlet. Verify that the container is clean and free of
d place the
s on page 10.
D VACUUMING.
er cord into the outlet. (fig. 4)
receptacle or
the container after draining container. (fig. 6)
se
r
move plug from power supply. Empty the container, clean and
ry the inside and outside before storage.
removed after wet vacuuming, and a cartridge filter must be
stalled before dry vacuuming again.
dust and dirt. (fig. 1)
2. Remove cartridge filter, then carefully install the foam sleeve filter over the filter cage an
power head back on the container. (fig. 2) See filter installing instruction
DO NOT USE THE CARTRIDGE FILTER FOR LIQUI
OPERATING INSTRUCTIONS – WET VACUUMING
3. Fit the desired nozzle to the vacuum hose. (fig. 3)
4. Verify that the switch is in the ‘O’ OFF position before plugging the pow
5. Turn the motor on by flipping the switch to the ‘I’ ON position. (fig. 5)
6. After use, empty the container by unscrewing the drain cap. Drain liquids into a suitable
drain. Remember to refit the drain cap to
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely in the
liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a float valve
that stops the suction action when the container reaches its maximum capacity. You will notice an increa
in motor speed. When this happens, turn off the machine, disconnect from power supply, and drain the
liquid into a suitable receptacle or drain. To continue vacuuming, refit the container with the drain cap. Afte
wet vacuuming, turn the machine off and re
d
REMEMBER! The foam filter must be
in
To Next Page
Loading...
