EasyManua.ls Logo

Char-Broil Performance Series - Cleaning the Performance and Advantage Burner Assembly

Char-Broil Performance Series
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Cleaning The Performance and Advantage Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting the grill.
1.
2. Remove cooking grids and vaporizer tents.
3. Remove two pal nuts, carry-over tube and burners.
4. Under grill remove grease pan and tray. Clean with soap and water.
5. Disconnect battery and under console disengage ignitor wire.
6. Wipe ceramic electrode with rubbing alcohol and cloth.
7. Clean carry-over tube and burners exterior with soap and water. Lay burners on flat surface, insert garden hose (preferably
with nozzle), into burner tubes forcing water through tubes. Make sure water comes out of every porthole. Open clogged
portholes with a thin wire. and examine porthole. Due to normal wear and corrosion some portholes
may become enlarged, if so replace burner. If any horizontal cracks appear from porthole to porthole or large holes (other than
portholes) are found replace burner.
8. If grill is to be stored, coat burners lightly with cooking oil. Wrap in protective cover to keep insects out. If not storing use
following steps.
9. Attach ignitor wire to electrode.
10. Reposition cooking grids and vaporizer tents. Place clean grease tray and pan into grill bottom.
11. Before cooking again on grill, perform a and .
Do not use ceramic briquets or charcoal in your grill.
Performance and Advantage Series grills are equipped with a removable grease tray. Although grease will drain from the
grease tray to the grease cup provided, food particles and debris may accumulate in the bottom and should be removed after
cooking 5 to 10 times. This can easily be done by sliding the grease tray out of the rear of the unit. Make sure in replacing the tray
to push it all the way forward.
Turn gas off at control knobs and LP cylinder.
Shake out excess water
VERY IMPORTANT: Burner tubes must engage valve openings as shown (A).
Cleaning the Performance and Advantage Grease Tray
Replace battery.
“Leak Test” “Burner Flame Check”
s
Burner
Carry-Over Tube
Vaporizer
Tents
Pal Nuts
Burner
Tube
Valve
A
Burner tubes correctly
engaged in valves

Other manuals for Char-Broil Performance Series

Related product manuals