13
Vaporizer Tents and V-Bars
• Stainless Steel:
• Porcelain Coated:
• Chrome plated wire grate(s):
• Porcelain grate(s):
Plastic parts:
Remove from grill and tap to loosen any
scaling. Brush vigorously with a stainless steel bristled brush to
remove any additional scaling, rust or residue.
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use non-abrasive scouring
powder for stubborn stains.
Wash grate(s) with
concentrated grill cleaner or use soap and water solution. Dry
thoroughly and store indoors between cookouts.
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use non-abrasive scouring
powder for stubborn stains.
• Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
• After extended use and exposure to weather, paint on grill may
change color slightly or become spotted. Although this detracts
from grill’s appearance, it will not impair its performance.
• To refinish your grill brush outside of grill lid and bottom with
wire brush and lightly sand with fine grit sandpaper. Sanding
allows new paint to adhere more easily. Wash grill lid and
bottom with soap and water to remove dust and grease. Do not
use a grill cleaner on outside of grill. Wipe with vinegar.
Refinish outside with heat-resistant paint. Do not paint inside of
grill.
s
Repainting Your Grill
Storing Your Grill
• Clean cooking grate(s) and discard old briquets.
• Store in dry location.
• When LP cylinder is connected to grill, store outdoors in well-
ventilated space and out of reach of children.
• Cover grill if stored outdoors. Choose from a variety of grill
covers offered by Char-Broil.
• Store grill indoors ONLY if LP cylinder is turned off and
disconnected, removed from grill and stored outdoors.
• When removing grill from storage follow
instructions before starting grill.
“Cleaning Burner
Assembly”
CAUTION
FACT: Sometimes spiders and other small insects climb into
the burner tubes attached to the burners. The spiders spin
webs, build nests and lay eggs. The
webs or nests can be very small, but they
are very strong and can block the flow
of gas. Clean burners prior to use after
storing, at the beginning of grilling season
or after a period of one month not being used.
NATURAL HAZARD • SPIDERSNATURAL HAZARD • SPIDERS
Spider guards are on the air intakes in an effort to reduce this
problem, but it will not eliminate it! An obstruction can result in
a "flashback" (a fire in the burner tubes). The grill may still
light, but the obstruction does not allow full gas flow to the
burners.
Smell gas.
Burner(s) will not light.
A small yellow flame from burner (should be blue).
Fire coming from around or behind control knob.
Follow the “ ” instructions. Clean
burners often. Use a 12” pipe cleaner to clean out the burner
tubes. You may also force a stream of water from a hose
nozzle through burner tubes to clean them.
IF YOU EXPERIENCE THE FOLLOWING:
1.
2.
3.
4.
STOP!
Immediately turn off gas at LP cylinder!
SOLUTION:
Wait for grill to cool.
Cleaning the Burner Assembly
General Grill Cleaning
• Keep the outside of your grill looking new by cleaning it once a
month with warm soap and water or a non-abrasive cleaner. If
you don’t have a grill cover, wipe off dust and grime before
starting your grill.
• Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory . Apply a strong
solution of detergent and water or use a grill cleaner with scrub
brush on insides of grill lid and bottom. Rinse and allow to
completely air dry.
• Coating the cooking grids with spray-on cooking oil will keep
the food from sticking and make clean up easier.
• Check inside the grill bottom for grease build-up and clean
often, especially after cooking fatty meat.
(and should never be painted)
Do not apply a caustic grill/oven cleaner
to painted surfaces.
To Next Page
Loading...
Need help?
General
